Key USPsWhere Innovation Meets Quality
Consumer
| Tests | IS 2202 (Part 1) Requirements | Observation |
|---|---|---|
| Workmanship and Finish | Satisfactory | Satisfactory |
| Dimensions and Squareness Test | Length and Width within a limit 5 mm (+/-) | Length = +/- 5 mm Width = +/- 5 mm |
| Thickness within limit of 1 mm (+/-) | Thickness = +/- 0.8 mm | |
| Door Shutter shall not deviate by more than 1 mm | Within limit | |
| General Flatness Test | Twist, Cupping, Warping not more than 6 mm | Within Limit |
| Local Planeness Test | Depth of deviation not greater than 0.5 mm | Within Limit |
| Impact indentation Test | Not more than 0.2 mm | 0.2 mm |
| Flexure Test | Residual Deflection should not be more than 1/10th of Maximum deflection | Within Limit |
| Deflection at max load should not be more than 1/30 of length and 1/15 of width | Within Limit | |
| Edge Loading Test | Deflection of the edge at the maximum load should not be more than 5.0 mm | 3.24 mm |
| Residual deflection should not be more than 0.5 mm | Within Limit | |
| Lateral buckling should not be more than 2 mm during loading | 0.34 mm | |
| Shock Resistance | No delamination should be observed due to light and heavy body impact | No Delamination |
| Buckling Test | Residual deformation should not be more than 5.0 mm | 3.22 mm |
| Initial deflection should not be more than 50.0 mm | 22.50 mm | |
| Slamming Test | Shall not have any visible damage | No Damage |
| Misuse Test | There shall not be any permanent deformation | No Deformation |
| End Immersion | There shall be no delamination | No Delamination |
| Knife Test | Excellent or Minimum Pass Standard | Excellent or Minimum Pass Standard |
| Glue Adhesion Test | No delamination shall occur in glue line | No Delamination |
| Screw Withdraw Resistance Test | Not less than 1000 N | 1120 N |
