Century Veneers Natzura Wood

115 The types of cut determine the design pattern on the veneer. The size of the log, the wood species, the grain pattern desired and other factors determine which type of cut will be made to create the veneer. Here are some of the more common methods of cutting logs: Often referred to colloquially as a ‘ owery pattern’, this design is obtained by slicing the block parallel to the centre of the log. This results in a raised cathedral or ower effect by the innermost growth rings. For this method of cutting, the log is centred on a lathe and turned against a broad cutting knife set into the log at a slight angle so that a continuous cut is made around the log. This results in a wild, varied design. To obtain this design, a log is first cut into four quarter blocks. Then each block is sliced perpendicular to the annual growth rings of the tree. This results in a straight grain appearance on the veneer. This method is generally used with Red Oak and White Oak to minimise the appearance of flakes in the final design. This is derived by slicing the block at a slight angle by cutting slightly against the modular rays. This also results in a straight line design. Flat Cut Red Oak Quarter Cut Red Oak Rift Cut Red Oak Rotary Cut Red Oak CUTTING METHODS FLAT/CROWN CUT QUARTER CUT ROTARY CUT RIFT CUT